Posted by MeAnthony on October 22, 2011 at 06:08:09 from (74.204.60.35):
I have a '91 Dakota, V6, 5 speed, 4x4. The throwout bearing is slightly noisy, probably due to the fact that it sat for a couple years; previous owners couldn't figure out that the pick-up plate in the distributor was bad.
My oldest son used the truck, called me after he brought it back, said the transmission was making noise. Short version of the story: he put about 100 miles on it with no oil in the trans. Instead of calling me when the noise first began, he decided to haul furniture for his mother(my ex), take his girlfriend home, etc... but that's a whole 'nother topic on common sense and why it isn't so common any more.
So...I now have a used trans to go back into the truck. I was told it had been rebuilt. I agree that it makes sense to put a clutch kit in it while it's apart anyway.
However, I can't afford to spend $170 on parts, and then possibly find out that the trans isn't as good as I was told.
I can deal with having to pull the trans again next summer to do the clutch if it's necessary. What I'm hoping to do now is solve the problem that I KNOW exists(noisy throwout bearing) because I don't want that to mask any other noises that the trans may potentially be making.
Is there any way to lube the throwout bearing? Needle tip on grease gun? Submerge in heavy oil? Or is it completely sealed and I'm wasting my time?
Another thought I just had: IIRC, the in previous trans was worse with the clutch released. Was it maybe a bad input shaft bearing in the old trans? Doesn't a bad throwout bearing make more noise when the clutch is depressed, hence putting pressure on the throwout?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
