Posted by dstates on October 08, 2011 at 16:34:51 from (173.27.152.160):
Hello everyone. I'm in the middle of building a new house. We should be moving in around Dec. 1st. We're at the point where we could pour the driveway now or wait until spring. I'm torn because I'd like to have it done and avoid the winter on a gravel drive, but I don't want the ground to settle more and cause the driveway to sink.
It will be a concrete drive about 20 yards long from the curb to the garage. I know concrete will eventually crack and that can't be avoided, I just don't want the big bump as you pull into the driveway like my old house were the driveway setteled so much.
After some advice from a neighbor I'm "water staking" in front of my garage (started today). I've got a 4-5 ft long copper pipe with a valve on one end where I can hook up my hose. In some places it is very hard to work into the ground, but in other spots it slides right in.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
