Posted by TJ in KY on September 30, 2011 at 08:14:29 from (74.139.91.125):
In the last 2 weeks I have rebuilt the carburetor and adjusted the governor on my MF 230 gas tractor and it was running very good so I decided to do a little bush hogging. I got a little ways away from the barn and all of the sudden it started running real rough. Like maybe running on 2 cylinders. It kept running so I opened it up to full throttle and it was still rough but by the time I got to the barn it was running smooth again. I checked points and plugs all seemed fine so I headed out to bush hog again.
I thought maybe a valve got stuck or a piece of carbon holding a valve open, I don’t know. The tractor does not get much of a work out, but it seems smooth as silk now. I thought about adding some ATF or marvel mystery oil to the gas for lubricating the valves upper cylinder area, anybody got any thoughts on that. How much should I add??
It ran fine for an hour and a half, better than it has ever run, in fact, and then a limb or something knocked the valve stem off one of the rear tire and fluid starts going everywhere. I was able to force a bolt in the broken off stem, and limp it back to the barn, but the rim is shot (2 by 4 inch area gone) so I guess I will be looking for a source for a new or used rim (6 loop style). Always something.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
