Posted by Tony in Mass. on September 22, 2011 at 18:33:05 from (71.233.164.20):
How can I shorten this deary saga? Bought a junked MF3165, with the Perkins 212 gas engine. It had a bad case of hydrolock and then left to seize the rest. Sleeves didn't hone out as nice as you'd like to see them. So in the fight to remove them, all pistons are basicly shot. NO kits with pistons anywhere for this. Worthington said their kits did, but don't. Found a matching connecting rod on Ebay. So I've got rings and sleeves,etc... but it was such a fight to get the pistons out, I can't immagine those sleeves budging a bit. I am getting some used pistons from fawcett's in Ontario, have no idea what they will mike to, but I would feel better if I was using the 3 (!) new sleeves Worthington sent. But gettting dry sleeves out may be a trick someone one here knows... sorry for the length, and thanks in advance!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.