Posted by jessejmc1979 on September 20, 2011 at 09:37:20 from (168.251.194.19):
I am new here so I will dive right in with some questions. We have a little over 9 acres of which 5.5 is hay about 2 pasture and 2 yard. We also have 3 horses and currently 1 steer. We have been baling our hay (small squares) on a half share with a neighbor that has horses also and it has worked great for 3 years. But as we were getting ready to bale 2nd crop this year we got to talking and his hay mow is pretty much full and he doesn't need the hay anymore and doesn't want to bale for the money. He said that he would continue with our arrangement until I can find my own equipment but it was time to start looking. He also isn't getting any younger as he is 72 years old. I know that I could hire someone to do it but nobody around has a small square baler and I don't like depending on somebody when we get a window to bale and they are busy putting up there own hay (I don't blame any farmer for that because there stuff has to come first) but that window might be the only one. I know that I'm not going to get rich doing it myself but I enjoy "pretending to be a farmer" and have been around it my whole life. To make a short story long I found a completely restored ford 861 new tires/rims, tire chains and a back blade for $6,000. But I also found a wd45 that is in very good shape with a 3 point, and loader for $2800. I know that either one would run a small square baler but it seems like parts for the 45 are more readily available, and cheaper. What do you guys think? I know the ford is restored but parts are still gonna break and when they do I need parts and that parade ready paint won't matter much if I have hay cut and am waiting on a part. Thanks in advance for any info.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
