Posted by Crazy Red Power in SE-WI on September 15, 2011 at 20:00:28 from (24.183.132.223):
Unless it's trailered. I had something lined up, but it was just too expensive. That, and the hauler has to drive an hour & a half to move my chopper 20 miles to the show. So, I figured I'd drive it instead & began the inspections of road-worthyness. Simple lube points first! I always run across mechanical issues when I crawl all over a machine to find fittings. I found fittings that have all THREE layers of paint intact! The next issue I found was the rear wheels, the bearings are either shot or were not tightened after there last repacking. Provided they were repacked. The king pin (axle) was not taking grease, so I figured I would pull it, clean it grease it & put it back. No. The pin is not leaving the axle, even though the axle saged down a quarter-inch when I lifted it off the ground. To shorten the story, the gear selector box is jammed, again, the variable drive belt squeals & squallers for no apparent reason, the engine did something with a half-gallon of 30W in a half-hour's run time & don't know where it went, my manifold isn't here yet, I p'd away last weekend looking for manifold gaskets that no longer exist & I have a dent in my head from smacking it on the infernal confounded frassin' spout that's three feet too short. Oh, I'm also missing a few zerks, not that THAT is anything new. I was told that long ago. Aw, the humanity!
So..... unless the planets align & all the parts fall where they're supposed to, that poor death trap probably isn't going very far for a while. My apologies for going on, I'm just having a time of it. I will still go to check out the show, meet some good people & take plenty of pics.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
