Posted by gitrib on August 25, 2011 at 11:52:25 from (99.75.34.181):
In Reply to: Re: O/T Shocking Corn posted by Pitalplace on August 25, 2011 at 07:50:14:
You got it right. Whe I was little I use to help my dad. His Corn binder had a bundle carrier and he would dump so many bundle in a pile. this way he could sort of dump the piles in a rows so he would not have to carry them to far to build the shock. He alway carried a little pail wirh a ball of binder twine and a had a lite weight rope with a pulley tied on one end. When the shock was as big as he wanted he would throw the pulley around the shock run the rope throgh the pulley and draw it up tight then put a strand of binder twine around the shock and tie it off. he never had any shocks blow apart. Ended up hauling it to the shredder Was blown on wire frame to use has calf shed in winter Raised some good calves on the stover See they were not so dumb.We are running around baling corn stock today. gitrib
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.