Posted by JD seller on August 20, 2011 at 17:58:23 from (208.126.196.144):
The corn was looking pretty good after we had some blowen over by high winds three weeks ago. Some of the fellows have had pollination problems on ear leaning too far over. The ear may not have any kernels on the low side.
Then ten days ago we started seeing Goss Wilt hitting the corn down around Cascade pretty hard. It is affecting much of the corn now. I am told that the high winds damaged the leaves and that allowed the Goss wilt to take hold faster.
I had never even heard of it until last year when a good friend finally diagnosed a problem he had in a field for several years. It was Goss Wilt. This field is hard to get to after the crops mature. The corn would look great as late as Mid July and then when you harvested it he was only getting 100-110 bushel corn in the field.
This is harbored in the fodder so fall tillage help control it. My friend never does fall tillage as he has stock cows that he runs on the stalks until snow. Also you DO NOT WANT TO bale the fodder and use it for bedding. When you spread the manure you are spreading the Goss Wilt.
The best control is some varieties are resistant to it. So far there is not any chemical control for it.
It is a real shame. These guys had a great crop going and all at once they may get half a crop. The Goss Wilt can cut yields by half real easy.
I have attached an article about the Goss Wilt. They go into the scientific names and explain the way it looks.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
