Sure, you can use a saw with a diamond blade to cut them (always cut wet if you can). One problem is, if you can see the cut end, it looks out of place. You can cut it long and use a chisel to rough the end up and make it look more natural though. Its just doing it that way is kinda doing it twice.
For a decient sized job, it would end up easier to just rent or buy a stone splitter. If you buy a used one, you wont be using it enough to make it worth less when you are done with the job so you could re-sell it for what you bought it for. You may be able to long term rent a splitter from a mason contractor (its not like they will be using it on jobs in this economy). Tool rental places should also have a splitter but with per day charges and a job you may not be wanting to pound out in a weekend, the rental fees add up quickly.
As mentioned, wedges will work but that also brings up a few other issues. First is you will need a good hammer drill to make a bunch of holes to put the wedges in. Second, when done, you will have a nice split edge with a bunch of half holes showing from the hammer drill. Not a problem if that edge is covered but if that edge is covered, may as well just cut them with a saw.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
