Posted by 37chief on August 11, 2011 at 14:51:49 from (70.181.168.186):
I have been working on a 52 plymouth flat head 6. I was measuring the crank thrust, and it had none. So I removed the rear main with the thrust area, and scraped off a little, reinstalled the bearing shell still had no clearance. What could be wrong? What happened, was moving the crank in the same direction each time. By he time I figured out what was wrong I had too much clearance. So I am going to be out 80.00 for a complete set of mains just to get one rear bearing. Last time I made an expensive mistake, was running my JD diesel on 75 % gasoline. That cost 600.00 for a pump rebuild. Maybe it's time to move to a small apartement and just sit and watch tv all day until I die. Day is just about done, hope I don't do anything else stupid. stan
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.