Posted by dave2 on August 09, 2011 at 03:52:44 from (139.139.35.70):
Help me out with a brainstorm please or stop me before I ruin something.
Just got a couple metal fence charger boxes that have a place to fasten the 12 volt fencer so that the nuts are inside the battery compartment that is lockable. These aren't the fancy type that are set up with a key so that anyone without the key gets shocked when touching the box. However, and this is a two part question...
1st) After I get everything ogether and the battery in, can I ground the fencer ground terminal to the metal box then with another (heavier?) wire, ground the box to the actual grounding rod and still get the performance out of the charger?
2nd) If so, will this have the addedbenefit of whoever touches the box while the charger is on getting at least a tingle? This is not as important as being able to do as in the 1st question.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trailering Your Tractor - by Curtis Von Fange. One of the fun things of summer and fall are the parades and tractor shows that go on across America. Many owners of tractors travel long distances to attend these shows and they usually take their restored iron along with them. Safe trailering practices and inspections will ensure that the event is a fun one. A good habit to develop when using a trailer is to give that ‘quick look over’ before taking it on a trip. Before hooking up to it check the tongue for proper operation. The latche
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.