More or less signs of "el raton" a rat. Well at least you can see the route they are running, smart little rodents too, some traps they may sidestep for awhile. I would eliminate all food sources, but we all know how horses eat grains and pellets, sprinkling the bedding, gathering most but not all back up, amazing how they can pick through things.
I would move the horse and use a mechanical trap, with something they really like, possibly grind up some cashews, (rats love those) and mix with some peanut butter to make it stick. I would place traps along their routes. These rodents have extra sensitive noses, they seem to pick up on things very easily by scent.
I hate using poisons, but like many horse farms, rats show up at times, we've rarely if at all ever had them around, but just like your stall, you can see in the shavings where they make a hole, just under the bottom board, I did use poison bait, which I do not like using at all. I placed it out of the horses reach, more towards the exterior of the wall, some outside. It worked and rid the place of them at the first signs they were around, so they did not get established. We have to make sure that the feed room is cleaned properly, and around the stalls as much as can be done. These were some large ones too, brown, you would find them staggering around, young too.
I prefer a mechanical trap, because I can see what I have, no dead carcasses in walls reeking. No poison to worry about, as well as in dead carcasses disposed of, I like to feed em to the crows. We have one good barn cat, he's lined up 9 mice in a row, thats his record at least, but the size of the rats, no way he would attempt it, to be honest I never saw any that size in all the years I worked in NYC, including ones I have seen in subways.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
