That cover you see may hold a dust/wiper seal but not the high pressure seal. You will need to clean everything up around the valve spool. Then remove the linkage and then that cover. The valve spool should then pull out the top of the valve. Be careful as there should be springs under the spool. Keep track of where everything goes. The spool may have orings in the valve body bore. These would usually have flat backup rings too. Your valve may not have sealing rings on the valve spools. Many valves depend on the fit of the spool/housing to keep the oil sealed. If your valve is that way then you will need to replace the valve section complete.
What brand of back hoe is it??? You should look at a parts diagram before tearing into it. If there are not seals then if you remove the spool it may leak worse. If there are not orings/seal then I would wait until I found a replacement valve section before I tore into it. You could make the old valve unusable.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.