Few things come to mind; when digging the hole for one, over dig, make room for stone and say some filter fabric, hopefully the ground is well drained if you use it a lot. Also make sure all your connections are tight, if using poly ( black plastic ) use extra clamps on barbed fittings, hose clamps seem to strip easier now then they did in the past. Check for leaks. One tool that is handy to have set up for clamps is a 5/16" socket on a ratchet, or the appropriate size for the clamp if used. Screwdrivers don't do it for me on clamps.
Get a quality hydrant with a parts diagram, there is a chance you may have to work on one of these at some point, I just replaced 2 that were less than 10 years old. Good to know you can get parts for them. Also, check the casting of the hydrant, make sure it has a big enough "nub" near the spigot to hold a bucket handle, some castings leave just a little one, barely enough.
I'm referring to "in ground type hydrant", hopefully you are not referring to a wall hydrant or something else.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
