Posted by PM BAKER on July 05, 2011 at 07:34:59 from (24.110.108.198):
I installed Westwood F100-14 Filter Vacuum Gauge on my MF30B, it normally uses a Donaldson ServiSignal mini indicator that shows a red flag when limit is reached. I installed the gauge because it tells me exactly what is going on 0-30hg, not just a red flag like the Donaldson.
I installed the gage, and new filters. I restricted the air intake pipe with my hand almost airtight, and the gage did not move from zero. I removed it and ran a wire up the connector into the intake air stream where the gage connects to the fitting, to make sure there are no obstructions, there were none. I reconnected the gage, and tried again restricting the intake, and with the engine revd up,the suction on my hand was strong, but the gage registered nothing. I think it's a defective gage. The manufacturer is sending me another.
My question is, am I right in my procedure for testing? How can the engine run if I restrict the air almost totally? It was just for like 10 seconds, but I didn't notice much change. Shouldn't I see black smoke or something?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.