I must respectfully disagree with the claim of 6V-53's needing a major at 3000 hrs. This is just plain hogwash. Remove the blower every 3K and put new gaskets under it? Absolutely. If there was a weak point in this engine, it was the thrust bearing.(and the blower gaskets). If a conventional clutch with high release pressure was used, the brass pins used to secure the thrust washer would shear off and the washer would spin in the block. This condition could go for years unnoticed. We bought an abused 6V-53 form the salvage yard to put in that LN-800 I keep yapping about; this engine spent much of it's life in an overspeed condition due to the throttle lever stop in the governor cover being worn out. Eventually ,it started knocking, found out later the crankshaft broke. Inverted the engine, with the heads still on it,lay a used crank in there, new rod & mains, re-install engine. This was back around '81 or '82, and I still put blower gaskets in it about every 15-20K miles. Another example of high-time 6V-53's is our '85 Koehring C366. Electronic hour meter checked out at 4500 hrs and the Hobbs meter I installed in the engine compartment reads 3787 hrs. So you can see why I think that friend of yours is not quite flush with the facts. Fritz.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.