Posted by KEH on June 22, 2011 at 13:30:31 from (67.231.167.114):
In Reply to: new holland 847 posted by andy zimmermann on June 22, 2011 at 12:41:43:
I had an 847. There is a disconnect link in each chain. Raise the lid a few inches and turn the baler until the repair link is in the opening. For safety, block the lid open. See if the link is at the same place on each side. See if there is an equal number of links between the bars at the repair links. If not remove a link and reconnect. It is possible when the chain was last assembled that the bars were not put in at the same place in the chains on each side. You may have to remove the bolts from one side and start over. After getting both chains to have the same number of links, run the baler and see it there is an improvement. Check operators manual, or it may be necessary to get a shop manual.
Not to be adding to your troubles, but the runners the floor chains run in get worn out. Also the bottom sheet metal can have holes worn in it from the bale turning.
Hint: when you get the baler working, I would stop the baler from turning after wrapping the twine and then eject the bale. The drive chain on the left side of the baler has a tendency to jump out of the track when the bale is left turning before ejecting. I added a side piece of wood to the wooden slide that chain runs on to keep the chain in place.
Another hint: The factory knife on mine would not always cut the twine. I made a deeper knife from a piece of mower knife section and had no more trouble.
Check the hinges at the top of the baler. I had one break and cause the lid to raise unevenly. Don't know if that is effecting the chain on yours or not.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
