Posted by Bob on June 14, 2011 at 13:14:03 from (64.255.159.192):
In Reply to: Re: Magneto Problem? posted by Adutkiewicz on June 14, 2011 at 13:04:53:
First, take off the little cover just under the rotor (2 screws) and see if the gears are correctly timed. Instructions are in the Blue Ribbon Service Manual at the link below.
Make sure the engine is rotated to the #1 TDC position at the end of the compression stroke.
Then, (before installing the mag) rotate the mag BACKWARDS so the impulse doesn't catch so the rotor points to the #1 high-tension tower. Set it so the points have just closed going backwards/begin to open when it's turned forwards.
Install the mag and the wires (in firing order).
Be SURE the kill switch is set to "OFF".
Rotate the engine exactly TWO turns, approaching #1 TDC SSLLLOOOOWWWWWLY, and verify that the impulse snaps AT (NOT before) TDC.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.