Posted by Christos on June 08, 2011 at 08:08:19 from (130.108.192.93):
Thanks for the suggestions on the carb - I pulled it off the tractor yesterday and opened it up and the new float I had put in two years ago fell apart - the soldering job failed.
I"ve worked on my carb in the past and I realize the TSX-882 is pretty easy to work on - there is some rust in the bowl and I think in one of the needle holes.
Is it worth taking it to a shop to have them rebuild it? I was going to take it to Denny"s but after searching the archives, I"d rather not. Hite in Columbus estimated it would cost me around $140 to reman it with a years warranty so I was thinking about having them do the work.
As for the starter the tab/plug is loose so I am going to have that looked at. Any recommondations for a competent shop in either Columbus or Dayton, OH?
I"m hoping *crosses fingers* at the end of the month I"ll be bushogging again.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.