I run mine with a PTO pump offered by Deere for tractors that don't have enough hydraulic oomph. The tractor I use is a IH 1086. I used to have a 7000 Deere planter and it did an excellent job as long as I kept the speed in the 4 1/2-5 MPH range. Like JD said, the finger units have to be kept in top shape. Planting speed has to be kept down but that goes for any planter, in my opinion. My neighbor has a 7000 finger that he bought new in 82. He treats the units like pampered babies, 'putting them to bed' properly at the end of the season and preparing them properly at the beginning of the season. He plants at 4 1/2 MPH. His stand is always the envy of the neighborhood, though some won't admit it. My opinion of the precision units for the vac planters is it helps the vac planter place the seed like a good finger planter always did. Will the perfect spacing make me money? I don't know, but it sure looks nice from the road. Hope mother nature can help that good looking corn of yours along for the rest of the season. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
