Posted by buickanddeere on May 29, 2011 at 06:16:38 from (173.243.46.130):
In Reply to: Appropriate fusing? posted by RayP(MI) on May 29, 2011 at 05:12:44:
There is sometimes confusion regarding motor protection. There is short circuit protection which is just protection against a near or dead short. Fuses are breakers are sized well above actual wire current capacity. IIRC as I"m on the road away from my code book. Something like 300% for ordinary fuses and 175% for breakers and slow blow D fuses. There is thermal protection to protect electric motors from overloads. Usually a 115% heater on the motor starter. or built into a small motor"s junction box. 30amp fast blow P fuse or 20amp slow blow D fuse. Has anything happened to drop voltage to the pump while starting? Has the pressure switch contacts started arcing? 2 wire or 3 wire pump?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.