You should be able to easily locate them if you do it right. Metal Detectors have a discrimination or screening setting. Must be set to accept the keys you are looking for. Might try it on another set of keys to test it. How deep were they plowed under ? Conditions vary and affect depth of detection. It also depends how big that wad of keys is. My key ring could be a boat anchor. Is your FIL knowledgable in detecting ? If he can't find them you would be welll advised to contact a local enthusiast . Some will do it for the thrill of the hunt and a good deed done. Others charge a fee. Findmall.com is one detector website where you could inquire.You may have a club near you. Also Law Enforcement agencies often have a detectorist they call to search crime scenes for shell casings and such. You might ask them. You also could check out White's Website. Contact a dealer near you. They will know someone who could come out and search it for you. Where are you located? I have been a lifelong metal detectorist and have several machines now. One cost me about $1500. It is a very enjoyable hobby. There are not silver coins laying at every search sight though as some people think. Some machines are very advanced with computer technology , multiple modes , etc, Not something one will master in a couple hours . Others are very simple like the wands that they use to screen people at airports. Hope I was some help. Let us know if you find them. Good Luck.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.