Posted by Dave from MN on May 11, 2011 at 05:14:38 from (75.94.148.103):
OK, Measuring the pressure at the port at the rear bottem of the MCV where the orifice is. I have about 1500# max pressure when you are turning the steering wheel. Disconncting a power steering line mid point, we had about 1 gallon flow in about a minute turning the wheel one way, and probably close to 5-6 gallons if turned the other way. The gauge we used was a 3000# gauge. We connected the gauge to the port on the brake valve that goes to the right brake, started tractor and it did not seem to really make any noticeable pressure on this gauge, but yet the brakes locked up. How much pressure does it take to apply the brakes so they lock like this? We took the pressure regulator off another tractor and tried it in this one and there was no change. Please note, that when you start the tractor, there is SO MUCH pressure on the brake pedals that you can barely push the brake pedal a half inch. Please recall that this brake valve was tried on another tractor and worked fine after it had been rebuilt. I can not find anything in the IT manual about how many GPM flow should be to the brake valve from the MCV? I did replace ALL 8 return springs in the brake covers. If the return(dump) line from the brake valve is open all the way to where it goes into the tractor transmission housing, is there anything that could be restricitng the dump flow after that? This is so frustrating, every one seems stumped. Pulled the flow control valve last night again, wondering if that should be replaced or swapped.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.