Posted by Don-Wi on May 06, 2011 at 20:29:43 from (75.207.38.246):
Got started today on replacing some steel on our 30+ year old (probably 40-45 year old) H&S Manure spreader. The side supports on the hitch were rotted and patched about 7-8 years ago and have since cracked again, so I was gonna try to just cut them out and replace them, leaving the center alone.
After cutting them out with the torch, and doing some looking, the center, by the time it gets to the drawbar hole, is bent up about 1 1/2", and it's got holes rotted in it in several spots. (Big surprise) Now, after only ordering 2 7' sticks of 4" channel for the sides, I need another 24 1/2' to finish the job, but this also means I can fab up the hitch itself at work on a large, flat weld table, with either a miller 200 or 350P wire welder, and have it come out much better than it would have in the driveway at the farm.
Didn't take pictures of before, as I hoped it wouldn't have to go this far, but I'll try to take some pictures as it is now with the hitch torched off and some as I build it up again.
Here's the only picture where it even made it in at all-
Probably gonna go ahead & repaint it after it's done. May end up going green though because the cheap red paint turns pink really quick without a clear over it, where the green still looks good 10 years later on something else I painted. Just something to protect the metal a little bit is what I'm looking for...
Donovan from Wisconsin
This post was edited by Don-Wi at 20:30:38 05/06/11.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.