Tool Talk Discussion Board |
Re: Pro Mac 610 Chainsaw Oil Pump Problem
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Butch(OH) on May 15, 2006 at 09:32:26 from (70.62.13.146):
In Reply to: Pro Mac 610 Chainsaw Oil Pump Problem posted by Wayne Mo on May 13, 2006 at 21:07:22:
Jeffcat has the 610 science down pat. People sure go through a lot to save having a $1 paint brush in the saw box and spending 10 seconds using it before adding fuel and bar oil. Even with a clean sump and pump some saws wont pump the super bar lube goo and there is no saw or chain brand that likes goo in the tank better than lube on the chain. In other words if your saw wont pump it in sufficiant quantities, it aint no good for bar oil period. If it means anything I have never bought "bar oil". When we had drums of 30 wt motor oil in the shop that was bar oil, when we had 15-40 that was bar oil and I have never seen ill effects as a matter of fact that was the reccomended oil for the older Echos. I have several 610-650 Macs myself and the 610 I bought new in 1976 has never had pump problem one so it can be done, clean and correct fluid. There are new pumps on an Ebay store right now for about $10 shipped to your door, can supply link if need be.
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: What's in Your Tractor's Toolbox? - by Staff. This recent discussion on the Tractor Talk discussion board here at the on-line magazine drew so much response and proved to be so interesting that we wanted to share it with you here. The names of the people participating in the discussion have been left out to "protect the innocent" (to quote a once-popular television series).
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|