Tool Talk Discussion Board |
Re: Re: Drill Bits
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Scott Green on July 21, 2000 at 17:57:25 from (209.130.137.196):
In Reply to: Re: Drill Bits posted by Dan from PA on July 21, 2000 at 15:45:23:
Dan from PA. , I know the feeling. I once had a tool grinder show me how to sharpen a drill bit. I was amazed at how easy it was. You just have to know how. Like you said , the best 10 minutes of education I had ever had. I was always so carefull not to get the bit dull. Now I don't care. When the bit gets dull , I resharpen it in 30 seconds or less. By the way , when you have a drill bit with a wide webbing , useing the corner of the grinding wheel , reach inbetween the flutes to grind the webbing thiner. This is called thinning the drill. The drill will go through metal / mild steel much quicker. Of cource a thinned drill bit will take too big of a bite on softer material , for example , wood , plastic , etc..
Follow Ups:
Home
| Forums
Today's Featured Article -
The Cletrac General GG and the BF Avery A - A Bit of History - by Mike Ballash. This article is a summary of what I have gathered up from various sources on the Gletrac General GG and the B. F. Avery model A tractors. I am quite sure that most of it is accurate. The General GG was made by the Cleveland Tractor Company (Cletrac) of Cleveland, Ohio. Originally the company was called the Cleveland Motor Plow Company which began in 1912, then the Cleveland Tractor Company (1917) and finally Cletrac.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|