Tool Talk Discussion Board |
Re: Copper Kettle
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by T_Bone on June 13, 2003 at 17:25:48 from (171.75.22.118):
In Reply to: Copper Kettle posted by Farmer Steve on June 13, 2003 at 09:06:12:
Hi Farmer, Take a wooden or rawhide hammer on a steel bench a lightly hammer the ding out. You can also use a steel hammer if you don't care if the finish is marred but use soft blows. CU expands easy when hammered. If you get a bubble, heat with a torch until it just changes color then cool with water, then reheat and let cool normal, removes stress. Use 1cup vinegar with a tablespoon of salt to remove tarnish. If the black is thick enough it will need scraped. If the tarnish is difficult then use amonia but renise well with water. T_Bone
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|