Tractor Pulling Discussion Board |
Re: 273 Buda mods
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Justin on March 25, 2001 at 16:58:39 from (63.147.180.206):
In Reply to: 273 Buda mods posted by TGW on March 25, 2001 at 15:39:40:
Unless you are going to grind your cam for clearance when you install the 262 crank, you will have to use the 262 crank. It is already knotched for clearance of the extra stroke. The 262's cam is set up for the slightly higher RPMs that the 262 turned, but will still work fine for your motor and give you plenty of low end grunt. Also the entire 262 motor will bolt up with minor modifications. Justin
Follow Ups:
Home
| Forums
Today's Featured Article -
An AC Model M Crawler - by Anthony West. Neil Atkins is a man in his late thirties, a mild and patient character who talks fondly of his farming heritage. He farms around a hundred and fifty acres of arable land, in a village called Southam, located just outside Leamington Spa in Warwickshire. The soil is a rich dark brown and is well looked after. unlike some areas in the midlands it is also fairly flat, broken only by hedgerows and the occasional valley and brook. A copse of wildbreaking silver birch and oak trees surround the top si
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|