Re: Tight lift-all pump?

Posted by Theman on January 26, 2001 at 11:27:35 from (204.149.23.2):

In Reply to: Tight lift-all pump? posted by Bergen on January 26, 2001 at 05:35:46:

Since the pump shaft turns right up to final torque, I would not suspect the gears. There may be an end-play issue that hasn't been addressed yet. Is the new gasket the same thickness as the old one? Perhaps the cover you are tightening down is moving in too close. In some cases, (may not apply here) shimming with gaskets of varying thicknesses have been used by many manufacturers to control clearances. I found this out the hard way on a mower gearbox. Had way too much slop until I started peeling layers off of the gasket until backlash was perfect. An old mechanic friend told me about this. It turned out to be four separate gaskets.

Follow Ups:

• Re: Re: Tight lift-all pump? Bergen 15:20:16 01/26/01 (0)

Post A Followup Name: E-Mail: Subject: Re: Re: Tight lift-all pump? Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]