Farmall & IHC Tractors Discussion Board |
Re: Re: Farmall M Hyd pump Removal Questions
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Haas on January 17, 2001 at 06:15:48 from (129.37.117.98):
In Reply to: Re: Farmall M Hyd pump Removal Questions posted by john d on January 16, 2001 at 17:37:59:
Don't think the M has a pin in to remove in the belly pump coupling. Mine has a "cross type" coupling. You have to turn it so the one of the crosses is vetical. Then it will just slide out when you lower the pump. I used 4 3/8 inch rods and nuts screwed into the bolt holes to lower mine out. If you do it that way, be sure the rods do not unscrew. That thing is heavy and you sure do not want it to fall. You can use the tractor with the pump removed, but be aware that all the clutch parts are exposed to dust and dirt. If there are any oil leaks at all, everything in there will be covered in no time. I'd make a cover to put over the opening in the bottom and plug up the holes in the sides with something.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|