What I would try is make a big easy out. I know, hate that word. Take a flat piece of iron just a little larger diameter than the pipe that is broken off. Bevel the edge a little and drive it in. Not too tight so as to stress the valve body. First off though, put some lint free rag or paper inside the spool bore to protect it from crud. On the other one, I would do a little tapping close to the threads and put a pipe wrench on it. Now, the way to avoid this problem in the future is to lube those threads when installing and do not tighten it very tight. There is nothing to leak out of those threads anyway as the o_rings hold the oil. What I do when I assemble the spool is to tighten that large nut really tight onto the pipe by putting the nut in a vise and using the pipe wrench on the pipe. Then the next time you can put a socket on the nut and it will screw the assembly out easily. If you don't like using a pipe wrench on it a chain wrench works also. A rag on the pipe wrench will keep from marking up the pipe (union).
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
