Posted by 1958johndeere620 on February 24, 2015 at 17:35:09 from (142.0.99.33):
Took the ole 300 in for some upgrades. I put a 1442 pertronix ignition system in with their high output coil. Also doing the 12 volt upgrade with delco alternator. I put an intake/exhaust manifold on from Stiener because I had a hole the size of a nickel in one of the exhaust tubes.The intake is the high output one offered by them. It is different only where the carb is supposed to get heat from exhaust side. They are not connected at the flange.Less heat = more power. They are not going to carry the stocker any more so I took what they had. After install my idle was way high. Around 1200 or better. I had to take the linkage apart at the governor connection point and take 2 full turns out then re attach the cotter pin. Why would the idle change so much by just replacing an intake and ignition? Did not even take carb off when doing the change over. Never touched anything. Kinda stumped.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
