Posted by Tom Fleming on February 16, 2015 at 05:42:05 from (67.20.239.72):
In Reply to: Is it possible posted by Dieselrider on February 16, 2015 at 04:51:10:
well, I have done it. Not the optimal situation. I don't recommend it, but in a pinch, a number of us have jumped a 6v system with 12 volts.
The positive vs. negative ground is just reversed polarity. so, the positive leg (terminal) is connected to the frame. As long as positive goes to positive, and negative goes to negative, that is all that matters.
There are horror stories around using 12v to jump a 6v system. I personally have never experienced it, but others will share their comments. After getting the polarity correct (red to red, + to +, etc), the main thing is, the only thing you should do is start it. do NOT turn on the lights, etc. I do NOT hook the jumpers up to the battery. I hook the positive to the frame, and then use the negative cable on the starter post. This is best if you have a magneto (which I prefer). Battery ignition will fail after you remove the jumpers if the battery is totally dead, and the charging system is not working properly.
The best route is to invest in a good 6v charger, one with a starting cycle setting on it.
disclaimer: my comments are to be used at your own risk. I have been working on mechanical things for almost 50 years now. there are things I do in a pinch that are not for first timers or the faint of heart.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.