Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Farm All H Carb.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ltf in nc on January 11, 2001 at 16:45:37 from (206.228.214.240):
In Reply to: Re: Re: Farm All H Carb. posted by Dead H on January 11, 2001 at 14:21:38:
Dead H, the following entails a little more work but will identify the area of your problem. I am copying this from an old post and if you have any questions just ask. Remove the plug that is in the carb bowl. Get a barbed fitting from a plumbing supply with the same thread size and a short piece of clear tubing that will fit the barb. Mount the new fitting in place of the plug and put the tubing on the fitting and turn the tubing vertically with the open end up and tie the tubing in place. This will let you see the fuel level that is inside the carb. When the tractor starts dying look at your "sight glass" to determine if the fuel is present or if it has disappeared indicating that from the needle/seat valve back to the fuel tank there is a problem. Post your findings.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|