Early 560 came with a bull gear that would interchange with a M. But after that the teeth pattern was changed more than once on 560 tractors and also on early ones that got the full updates installed. IH had a update program. Updated bull gears or 560 tractors built after updates were factory installed don't mesh right with a M bull pinion gear. Axle spline size still the M size. Know of some that have ground the part of M clamp that goes in the keyway off and used them on a one keyway axle. Good chance they could fail at maximum pull and traction. M clamp used four 3/4 inch diameter bolts. 560 clamps used four 7/8 diameter bolts. IH did make a wheel for M type rims with axle clamps just like a 560 and a steel axle key. Came out about 1955 and looks just like a M wheel except in the clamp area. Used as a replacement wheel for previous tractors with 2.75 axles. At 560 serial number 13814 up axles were changed from alloy steel to a carbon steel and method of hardening changed from furnace hardening to induction hardening to increase the strength of axle.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
