Using a Hitachi 14231 aternator, use the same bracket but use a 3/8" threaded rod (grade 5) to go through the brackets to hold the alt in place. Use 3/8 pipe to make spacers to allow solid positioning. Attach the Big out put terminal to the amp meter (after reconnecting all amp meter wires to the opposite terminals to correct the reading with the different polarity of negative ground) on the terminal going to the lights and ignition sw. Connect a # 12 wire from that same big terminal to the S terminal on the alt (use a insulated 1/4" spade terminal this is a very short wire). Next run a #12 wire to excite the alternator from the L terminal (also insulated. It needs to have one of the following in series with it: A diode from radioshack, or salvaged from an alternator or? it needs to be of about 3 amp capacity or better, and placed so the current only flows toward the alt, Band end toward alt), or a side marker lamp (not LED), or a 10 ohm 10 watt resistor. these prevent the alternator from keeping the ignition on when you shut the tractor off. The other end of this wire attaches to the ignition switch terminal connected to the coil. Next use a ballast resistor From a mid 1960s Chevrolet at the coil to allow the use of the original coil. wire it in series with the original wire. Reverse the coil connections to assure that the Negative coil terminal is connected to the distributor, and the positive is connected to the ballast resistor. Replace the light bulbs with 12v of the same wattage, (or LED replacements much brighter). The Hitachi is just reliable as a stone, and tidy. Look in the archives for Hitachi and you will find many pics. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.