Posted by pete 23 on December 22, 2014 at 16:48:35 from (74.33.70.156):
In Reply to: voltage regulater help posted by flopguns on December 21, 2014 at 13:54:52:
Since no one is going to warranty a voltage regulator anyway, take the cover off and look at the points. Normally, not running , cutout will be open and regulator points will be closed. Then start it up to see if cutout closes to indicate it at least tried to charge. Watch the regulating points for arcing. If so, clean them with a dollar bill. If still no charge, ground the field terminal with jumper wire. That will show you if generator is capable of charging as it eliminates all regulation. I suspect your problem is the generator that is causing all your regulator problems. Not matched to a regulator. Probably a rebuilt unit with lord only knows what parts are used. I cannot tell you all the different things to check from here. Way too many but I do know what I would check like field current draw for a start. Too much field current burns up regulator points with regularity.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
