Farmall & IHC Tractors Discussion Board |
Re: F-30 questions
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Brad on January 08, 2001 at 22:49:52 from (163.41.62.106):
In Reply to: F-30 questions posted by Mike Schwartz on January 08, 2001 at 19:11:37:
Hi Mike: I believe what you have in the 32 is what is called, duck bill steering. The 35 uses a worm gear steering.( Serial number 7032-and latter, which is, 1935 and latter) The duck bill uses front bolster #2279 Dax and the worm gear uses #3548 Dx. The two are not interchangable. The duckbill bolster uses the front axle shaft #26288 D, and the worm steer uses #27876 Dax and of course if the 35 is on rubber, it even takes another front axle shaft, with a bushing for added heighth. Thanks for making me do my home work tonight. I believe I'm correct but if I'm not, I'm sure someone with more knowledge on the f-30 will set me straight. Brad
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|