Posted by The tractor vet on December 12, 2014 at 07:24:59 from (104.179.81.68):
In Reply to: 300U clutch posted by jeffcat on December 11, 2014 at 18:35:24:
Here is a trick i have used , The cover plate bolts are little SHORT 1/4 inch bolts and do not give you any wiggle room so ONE at a time remove one bolt and get ones that are about a 1/4 x1 bolt and put that in where you removed the one also to aid in this deal there are three shipping bolt hole in the cover and if and again i said IF my old memory has not gone completely i think they ae a 5/16th by one with a flat washer this will pull the pressure plate back against the cover plate and remove the spring pressure . IF the sprag is good you will be able to only turn the T/A flywheel one way so just work around it and once you have removed all the short bolts and replace to the longer ones just to holt it in place then you can take a pry bar and pop the disc loose from the flywheel. Once it loose then just replace the short bolt back in and remove the shipping bolt readjust the linkage and work it . NOW due to age ware and tare most times the BOOK INSTRUCTIONS for adjusting the linkage will not get the job done and here it comes down to a FEEL adjustment and you will have to learn that one for your self.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
