Posted by 350 dave on December 06, 2014 at 03:08:48 from (50.48.59.84):
In Reply to: 300U: Hyd filter? posted by redtom on December 04, 2014 at 16:31:02:
redtom- the filter is the screen under the seat. Lift it "STRAIGHT UP" when removing. Pull one bolt, buy 3 extras about 10-12 inches long. Grind off the heads. Takes out all the bolts (3 lengths)and number as to which hole they came out of. Use 2 short ones to mount a hunk of scrap chain across the holes in the center to make a handle. Not the res. mounting holes, the other ones in there, (you have the seat removed right?) Now get the young strong guy with no back problems to hop up and lift the thing straight up while you get some blocking under it, opposite corners. Look it over ( and under)and it all becomes obvious. That screen is about $160 Clean and reassemble. The new gasket is about $20. Don't use any gasket in a tube stuff. You will use to much and it will get sucked into that screen. No teflon tape either. Install the 3 bolts with the heads ground off finger tight on the corners, then the new gasket, now the resivour. The headless bolts will keep it all lined up nice. Now put the real bolts back in, you did number them right? email me if you need the bolt pattern
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
