Farmall & IHC Tractors Discussion Board |
Re: Re: brake job - Farmall Cub
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by David A on January 08, 2001 at 07:30:52 from (198.24.4.11):
In Reply to: Re: brake job - Farmall Cub posted by Stan on January 06, 2001 at 17:07:51:
As Stan said, the housing will be heavy. Maybe use a rope sling to a rafter? Also replace the oil seals while in there. Stan, I just pulled the left side on my SA last night. With all the sqeaking noise from the brakes I was expecting no lining left. Surprise, just glazed. Two rivets are a little close but I'm thinking of saving my $40 some dollars each and not putting the new bands in. My reasoning is that with only light use on this tractor, even a little bit of lining thickness will last a long time. An I being foolish? David
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|