Posted by Centex Farmall on November 08, 2014 at 06:31:06 from (72.105.165.14):
In Reply to: fixing burnt tractors posted by burnt-smta on November 07, 2014 at 20:10:19:
Was there still any water and oil inside the engine and trans/case?
It sounds like you are just re-using the cast iron pieces which I think would be ok as long as they did not get shock cooled. i.e. if they burned and got hot and then cooled off naturally they should be ok but if the fire dept. sprayed water on it while it was hot then I would worry.
Some machine shops clean blocks by baking them hot enough to burn all the oil and sludge off and some do a similar process to stress relieve cast parts for high performance. IIRC the temp for is in the neighborhood of 1000 degrees.
So the real question is how did it cool down? They harden iron by heating it to a certain point and then quenching it. So if anything you may surface hardened castings. Impossible for anyone to say without more info, mainly if it got sprayed with water or not.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.