Where you're at now, I would pull the belt pulley drive and then pull the top cover. With the help of a cherry picker it will only take half an hour. (with any cooperation from the bolts.)
Get three five gallon buckets, a 1 or 2 gallon pump sprayer and 5 gallons of diesel. Put one bucket under the case drain and one under the transmission drain and go to spraying. Use a rag or two and strain the diesel into the 3rd bucket and re-use. Things will get surprisingly clean!
The worst trash accumulates the transmission gears and under the bull gears (as you've already found). The metals and bits will settle out of the diesel right away and the rag will catch almost all the rest. Sitting overnight will allow a whole lot more to settle to the bottom of the bucket.
With the cover off, check how much play is in the pilot bearing and input shaft assembly.
If it were mine I would pull and re-seal the axle housings too. They are usually full of old grease from greasing the outer bearing. It won't hurt anything to leave it, but while you're in there.....
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.