Posted by Owen Aaland on September 28, 2014 at 19:48:01 from (216.47.34.49):
If you put a Tee into the pressure side from the pump and then run it through your loader valve(s) and then back to the reservoir you will lose your steering except when the loader valves are in use and have a load on them. By installing a Tee before the flow divider valve all the flow will go in the path of lowest pressure. An open center loader valve will just allow all the flow to return to the reservoir and nothing will flow to the steering or hitch. If you use a closed center valve the hitch and steering will get flow when the valves are not being used but if you try to use the loader there will be no pressure since all the flow will still pass through the steering or hitch valves.
The engine driven pump is rated at 9 gpm and with power steering half of this flow goes to the steering and will not be available for the hitch or auxiliary valves. If you have an auxiliary valve or add one to the hitch hydraulics you will be limited to 4.5 gpm with the engine at rated speed. I'm sure you existing set up has much more flow than would be available from the engine driven pump.
The optional front PTO (engine crankshaft) for the 2424 is a 17 gpm pump that operated just the loader. That is what I have on my 2444 and makes the loader very useable even at low engine speeds.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
