and the top picture shows what looks to be my distributor, other than the lack of IH part# on the casting. It shows a similar screw in the side and 'weep hole' on the stem at about 1 o'clock (from the clip at 12 in the picture). My TC39 is still MIA, so part lookup is difficult, but the in the light of day I see the inner dust shield has an IH 353900R1 on it, which along with DSlater's distrib coding info gives absolute certainty.
As for it outlasting me, I rather doubt it unless I don't make it through the rest of the month (which is possible, but unexpected). The shaft shows ~.016 wiggle measured on the cam block, both side to side and top to bottom, so it needs to be rebuilt, but that will have to wait until either it isn't needed daily, or I have a spare distributor to work with. The later may be coming, as I have a line on a mostly complete but 'stuck' A for parts (or project) - just have to make the time to go pick it up (and space in the shop to work on something else).
Mr Slater, I corrected and completed the serial numbers in the first post, and while closer than the original off the cuff guestimates, the engine is still "older" than the tractor by at least 18,566 engines, unless the left seat bracket was replaced, and that is even less likely.
I have absolutely no history with this tractor - an elder cousin got it probably 9 years ago from a deadbeat as collateral/payment for some money he loaned. No idea who as he didn't want to talk about it. He was going to give it to me about 6 years ago because I had a use for it and he didn't. I paid him $1600 for it; at the time probably more than it was worth, but I'm quite certain less than he had loaned, and with a little TLC (Tractor Longevity Care) it's since proven it's worth a few times over. Cousin died 2 years ago at age 90. It is what it is.
Well Worn
(thought I'd made this post last night, but didn't see it today... ?)[/url]
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
