Posted by rankrank1 on September 24, 2014 at 08:19:31 from (166.137.101.149):
Went to cut hay with the mower conditioner (Hesston 1120) and the Farmall M late in the evening last week. Hay was tough from rain earlier in the day plus the evening dew was setting on around dark so all in all a real cutting challenge for any sickle based machine...
Anyway, The Farmall M got to running so poorly that I could not stand the sound of it on my ears (multiple random misses). It literally hurt my ears to hear the engine run. Not to mention the power was reduced. I was fearing stuck valves and bent pushrods.
So I unhooked the Farmall M and hooked the Farmall h to the moco and finished cutting by around 10:00 pm. Hay being tuff from dew and moisture put a good load on the ole h but she gotter done.
Next day after work stopped by Advance and picked up 4 Autolite 3116 installed in place of the brand new Champion D16's that the previous owner had installed in the M. Wow engine ran so smooth it was amazing and I used the tractor to rake once and bale with. (I was relieved no stuck valves)
Since the Autolite 3116's worked so well in the M, I decided to pick up 4 more and install in the ole h for good measure. The ole h had well used Champion D21's in it. Tractor runs a hint better with the new plugs and I seemed to eliminate an occasional slight flutter that the h used to have. Bush hogged with the tractor afterwards and did notice a seat of the pants power increase.
The like new Champion D16's are going in the scrap bucket (too cold of a plug). I will keep the old well used D21's for emergency spares which I hope I never need. The 2 ole farmalls will get Auotlite 3116's as long as I own em.
Moral of the story: for $17 ($2.09 per plug) I got two tractors that run better. One way way better.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
