Can't be sure, but the first block has a replacement block number stamped in for a row crop tractor. Some clues would be a small plate retained by 2 bolts near carburetor on the block. A dipstick or opening drilled for one in the block with a plug in the hole and no engine serial number. Probably cast in 1964 since block # 6943DJ or the original M block casting # suffix was lower than DJ in 1941.
C-264 block was cast in 1952 and I don't recognize that number they stamped in. Should be a 356980R1 or a replacement block # 365586R1. Looks like it has a engine serial number and may have started as a SM or SW6 engine. Could be a service engine # stamped in, but don't think so.
The C-264 block would have originally had a raised casting number like the 281 block before it was ground off. But it would have ended in R1 and be one of the 2 numbers I posted above.
Almost all 248 blocks didn't have the size cast on them. There is some that did, but a small percent.
If the raised place to right where the engine serial number is on the C-264 is the place you question? On a c-248 the serial number was on a similar raised place on toward the front of the engine. If that engine has one. On the 248 the original raised 4 numbers before the DJ were ground off.
This post was edited by D Slater at 05:20:04 09/18/14 2 times.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.