Posted by FC Andy on September 08, 2014 at 17:15:14 from (74.126.84.52):
Ok, So I'm finally starting to put the Range transmission and final drive back together on my 806. I know, I owe some pictures. It turned out to be worse than I thought, the pinion gear was trashed, too. I got a new one from IH (Ouch!) What I now would like to know, Is there anything I should be doing special? Like Special procedure for tightening the nut on the range trans. main shaft? (It was not very tight when I took it apart.) Also, in Bermuda Ken's book, he mentions drilling the casting and removing the plug behind the inner axle bearing race so that oil readily flows between the rear end and axle castings. Is this an update in the 56 or 66 or 86 series tractors? Also, is this recommended to be done? (By IH or individuals) I'm also wondering, in general, is there anything that I NEED to know that is not in the IH service manual? Like things learned by experience? Thanks! -Andy
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.