Posted by Eastsider on September 04, 2014 at 12:52:25 from (158.222.91.2):
In Reply to: New Shop posted by rnicholas on September 03, 2014 at 17:42:55:
I have a very similar shop...28x36. Double garage door on the 28 foot South wall. I had the garage door installed closer to the West side for arranging things and access from my alley. Along the East side, I have the walk in door, a 12 foot workbench with a vise, my rolling tool box, and a bead blast cabinet . I have pegboard over the workbench for storing various things. The North wall has some old kitchen uppers and lowers with a small countertop for storage. Also has the 110 wire feed welder cart, a drill press, the miscellaneous wood and iron pile, a rolling welding table and the engine stand and cherry picker in their stored positions. Along the whole West Wall and part of the North Wall I built hanging shelves from the ceiling down...three shelves about 18 inches to 2 feet between each one. Under them on the floor is storage for miscellaneous parts etc... in the SW corner by the electrical box is a kitchen stove and 220 welder. The SE corner has a refrigerator and TV and coat rack. Lots of open space to fit tractors like yours....I currently have an H, an A and a 200 in there with room to spare to work on other stuff...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.