1) Is 12 volts most logical, may well be, but I just prefer original equipment. Your tractor only YOU can make that choice.
2) Sure, maybe an M that must be started in extreme cold temps is a better choice for a 12 volt conversion, but an A etc should start fine with a 6 volt system if all else is anywhere near in good shape.
3) "I am told the regulator intended for 2 brush will not work and that i need a cut out and resistor controller for the generator"
Partly true but not necessarily 100% correct. a) Its possible to re wire to convert your genny to a 2 brush b) Ive seen BOTH 2 and 3 brush gennys that used a Voltage Regulator instead of a cutout set up c) If I converted a 3 brush over to a VR system I would move the adjustable brush as close as possible to the fixed brush.
SO IT IS POSSIBLE TO CONVERT YOUR GENNY TO USE A FULL FLEDGED VOLTAGE REGULATOR but it may not be for the timid and may take a bit of knowledge or even experimentation.
Looks to me like it may be simpler to just get a 2 brush and a VR to match it and go that route. The alternative is to stick with a cutout and LHDB light switch.
MANY PROBLEMS IN YOUR SYSTEM IS THE LIGHT SWITCH HAS A POOR GROUND OR ISNT WIRED CORRECT. ID TAKE A LOOK AT THAT FIRST. If your genny charges that well with F grounded maybe all you need is to insure a good ground on the LHDB switch or its bad, maybe has a bad field resistor. Is F on genny wired correct up to the switch??? Is switch well grounded????
Try to fix your genny F to ground problem may be all you need
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.